rotary cutter gearbox
rotary cutter gearbox
RC-twenty Series
Requirements
Torque: one,750 – three,267 lb.-in.
198 – 369 Nm.
Ratios: 1:2.5, 1:two.eighty three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: sixteen oz. (.47 L)
Weight: 34 lbs. (15.four kg)
Applications
Finishing Mowers Rotary Cutters
Rotary Slashers Toppers
RC-27 Sequence
RC-30 Series
Specs
Torque: two,800 – four,667 lb.-in.
316 – 527 Nm.
Ratios: 1:one.forty seven, 1:one.71, one:1.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 23 oz. (.68 L)
Excess weight: 51 lbs. (23.one kg)
Applications
Ending Mowers Rotary Cutters
Rotary Slashers Toppers
RC-51 Sequence
Requirements
Torque: two,800 – four,667 lb.-in.
316 – 527 Nm.
Ratios: 1:1.forty seven, one:one.71, 1:one.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Tapered Roller/ Deep Groove Ball
Oil Cap: 27 oz. (.80 L)
Bodyweight: fifty six lbs. (25.four kg)
Programs
Rotary Cutters Rotary Slashers
Gears: Accessible with both straight bevel or spiral bevel gearing.
Energy: Hp & Torque primarily based on AGMA formula for steady obligation additionally a service or load class element.
Shafting: Numerous dimensional, metallurgical, and heat-treat alternatives accessible.
Bearings: Geardrives offered with a variety of bearing lifestyle options.
Lubrication: Drives obtainable with numerous lubes based on running qualities
Substitute Rotary Cutter gearbox, 40hp rated, one-three/8″-six spline input shaft, one.57″ X twelve tapered spline output shaft and one:1.47 speed up ratio. These gearboxes have a sq. housing configuration and are similar in mounting and ratio to the spherical configuration gearboxes. These are unique tools gearboxes on the IM402, IM502 and IM602 sequence rotary cutters which featured slip clutch PTO shafts. This gearbox will not match the IM400, IM500 and IM60 models as they have a clean input shaft! If your gearbox has a twelve spline output shaft and a one-three/eight” – 6 spline enter shaft this 
gearbox will work. Bolt sample is four-three/four” on centre gap to gap and 6-three/four” middle to center of bolt gap on diagonal. The mounting holes form a square bolt sample.
rotary cutter gearbox
Have an interest regarding the rotary cutter gearbox?